Main Issues when Common Exhausting Dryers in Vertical Subdivisions IBC 2006: 716.5.3 Penetrations of shafts enclosures. The bottom of the vent terminal shall be located at least 12 in. A mechanical draft venting system of other than a direct-vent appliance shall terminate at least 4 ft (1.2 m) below, 4 ft (1.2 m) horizontally from, or 1 ft (30 cm) above any door, window, or gravity air inlet into any building. Side-wall Venting Z223.1-56-2006 (Venting of Equipment) 12.9.2Venting System Location. (a) A Venting system shall terminate at least 3 ft (0.9 m) above any forced air inlet located within 10 ft (3.1 m). Side-wall Venting Z223.1-56 - 2006 (Venting of Equipment) 12.9.1 Venting System Location. The exit terminals of mechanical draft systems shall be not less than 7ft above grade where located adjacent to public walkways.
Side-wall Venting Z223.1-51-2006 (Venting of Equipment) 12.4.3.6 Mechanical Draft Systems.
#Ebc12 modulating draft control code
IBC – 716 Penetration of shafts enclosures Īppliance Categorization Atmospheric Fan Assisted Forced Draft Scotch Marine Draft Hood Draft Diverter III I Condensing Positive Fan Assisted (high efficiency) Negative IV IIĬommon Code Violations (NFPA 54) Z223.1-2006 13.2 (Sizing of Venting Systems) (NFPA 54) Z223.1-2006 12.11.9.2 (Venting of Equipment)Ĭommon Code Violations (NFPA 54) Z223.1-200613.2.18 (Sizing of Venting Systems) (NFPA 54) Z223 Sizing TablesĬommon Code Violations (NFPA 54) Z223.1-2006 12.11.4.2 (Venting of Equipment) (NFPA 54) Z223.1- 200612.4.3 (Mechanical Draft Systems).
0 kommentar(er)
